Hallo, ich bin nun seit fast 48 Stunden am stueck an der einrichtung meines wlans.
Wlan Belink (Broadcast chip) und suse 9.1
router Belkin
desktop amd 1,5 ghz
512 ram
Ich habe dieses forum stundenlang durchforstet und alles ausprobiert.
zuerst habe ich den ndiswrapper, womit ich keinen erfolg hatte, probiert.
nun habe ich den driverloader von linuxant.com, womit ich meine wlankarte schonmal installiert bekommen habe.
in yast2 habe ich alle einstellung durchgeführt und komme leider nicht ins netz. wenn ich nun (sihe auch unten) das netz scanne(iwlist scan) finde ich zu einem den wlan meines mitbewohners und den Router(ebenfalls belkin) kann sie aber beide nicht anpingen. meine karte kann ich alldings anpingen.
ich habe alle moeglichen einstellungen probiert dhcp am router und auch mit statischer ip.
ich habe mal einiges uebernommen, damit ihr es euch mal anschauen koennt. Solltet ihr noch mehr infos schreibt es bitte. Kann einfach nicht schlafen...
kann leider nur ueber wlan ins netz, da ich grad kein kabel habe und wenn wir schon dabei sind koennt ihr mir ja zur not eine andere karte empfehlen, die unter linux 9.1 leicht zu installieren ist. diese ist dann wohl meine zweite option.
############## ifconfig ########################
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:106 errors:0 dropped:0 overruns:0 frame:0
TX packets:106 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:7194 (7.0 Kb) TX bytes:7194 (7.0 Kb)
wlan0 Link encap:Ethernet HWaddr 00:30:BD:99:93E
inet addr:192.168.2.2 Bcast:192.168.2.255 Mask:255.255.255.0
inet6 addr: fe80::230:bdff:fe99:93de/64 Scope:Link
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:36 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
############## iwconfig ###########################
lo no wireless extensions.
wlan0 IEEE 802.11g ESSID:"WG-LAN" Nickname:"lan"
Mode:Managed Bit Rate=11Mb/s Tx-Power=13 dBm
RTS thrff Fragment thrff
Encryption keyff
Power Managementff
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
################### route ###################
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.2.0 * 255.255.255.0 U 0 0 0 wlan0
link-local * 255.255.0.0 U 0 0 0 wlan0
loopback * 255.0.0.0 U 0 0 0 lo
default 192.168.2.1 0.0.0.0 UG 0 0 0 wlan0
##################### iwlist scan ###############
#####################mein router###############
wlan0 Scan completed :
Cell 01 - Address: 00:30:BD:C2:C8:30
ESSID:"WG-LAN"
Mode:Managed
Frequency:2.462GHz
Quality:1/1 Signal level:-66 dBm Noise level:-200 dBm
Encryption keyff
Bit Rate:1Mb/s
Bit Rate:2Mb/s
Bit Rate:5.5Mb/s
Bit Rate:11Mb/s
Extra:bcn_int=100
#######################etc/sysconfig/network/ifcfg-wlan0####
BOOTPROTO='static'
BROADCAST='192.168.2.255'
IPADDR='192.168.2.2'
MTU=''
NETMASK='255.255.255.0'
NETWORK='192.168.2.0'
REMOTE_IPADDR=''
STARTMODE='onboot'
WIRELESS_AP=''
WIRELESS_BITRATE='auto'
WIRELESS_CHANNEL='11'
WIRELESS_ESSID='WG-LAN'
WIRELESS_KEY=''
WIRELESS_MODE='Managed'
WIRELESS_NICK='mein nick'
WIRELESS_NWID=''
WIRELESS_POWER='yes'
_nm_name='static-0'
WIRELESS_FREQUENCY=''
#####################anpingen meiner karte mit statischer ip###
root:~ # ping 192.168.2.2
PING 192.168.2.2 (192.168.2.2) 56(84) bytes of data.
64 bytes from 192.168.2.2: icmp_seq=1 ttl=64 time=0.062 ms
64 bytes from 192.168.2.2: icmp_seq=2 ttl=64 time=0.059 ms
64 bytes from 192.168.2.2: icmp_seq=3 ttl=64 time=0.064 ms
64 bytes from 192.168.2.2: icmp_seq=4 ttl=64 time=0.061 ms
64 bytes from 192.168.2.2: icmp_seq=5 ttl=64 time=0.062 ms
64 bytes from 192.168.2.2: icmp_seq=6 ttl=64 time=0.060 ms
64 bytes from 192.168.2.2: icmp_seq=7 ttl=64 time=0.060 ms
64 bytes from 192.168.2.2: icmp_seq=8 ttl=64 time=0.059 ms
64 bytes from 192.168.2.2: icmp_seq=9 ttl=64 time=0.060 ms
64 bytes from 192.168.2.2: icmp_seq=10 ttl=64 time=0.061 ms
64 bytes from 192.168.2.2: icmp_seq=11 ttl=64 time=0.059 ms
########################## anpingen des routers #########
PING 192.168.2.1 (192.168.2.1) 56(84) bytes of data.
From 192.168.2.2: icmp_seq=2 Destination Host Unreachable
From 192.168.2.2 icmp_seq=2 Destination Host Unreachable
From 192.168.2.2 icmp_seq=3 Destination Host Unreachable
From 192.168.2.2 icmp_seq=4 Destination Host Unreachable
vielen dank fuer eure hilfe..
Wlan Belink (Broadcast chip) und suse 9.1
router Belkin
desktop amd 1,5 ghz
512 ram
Ich habe dieses forum stundenlang durchforstet und alles ausprobiert.
zuerst habe ich den ndiswrapper, womit ich keinen erfolg hatte, probiert.
nun habe ich den driverloader von linuxant.com, womit ich meine wlankarte schonmal installiert bekommen habe.
in yast2 habe ich alle einstellung durchgeführt und komme leider nicht ins netz. wenn ich nun (sihe auch unten) das netz scanne(iwlist scan) finde ich zu einem den wlan meines mitbewohners und den Router(ebenfalls belkin) kann sie aber beide nicht anpingen. meine karte kann ich alldings anpingen.
ich habe alle moeglichen einstellungen probiert dhcp am router und auch mit statischer ip.
ich habe mal einiges uebernommen, damit ihr es euch mal anschauen koennt. Solltet ihr noch mehr infos schreibt es bitte. Kann einfach nicht schlafen...
kann leider nur ueber wlan ins netz, da ich grad kein kabel habe und wenn wir schon dabei sind koennt ihr mir ja zur not eine andere karte empfehlen, die unter linux 9.1 leicht zu installieren ist. diese ist dann wohl meine zweite option.
############## ifconfig ########################
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:106 errors:0 dropped:0 overruns:0 frame:0
TX packets:106 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:7194 (7.0 Kb) TX bytes:7194 (7.0 Kb)
wlan0 Link encap:Ethernet HWaddr 00:30:BD:99:93E
inet addr:192.168.2.2 Bcast:192.168.2.255 Mask:255.255.255.0
inet6 addr: fe80::230:bdff:fe99:93de/64 Scope:Link
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:36 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
############## iwconfig ###########################
lo no wireless extensions.
wlan0 IEEE 802.11g ESSID:"WG-LAN" Nickname:"lan"
Mode:Managed Bit Rate=11Mb/s Tx-Power=13 dBm
RTS thrff Fragment thrff
Encryption keyff
Power Managementff
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
################### route ###################
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.2.0 * 255.255.255.0 U 0 0 0 wlan0
link-local * 255.255.0.0 U 0 0 0 wlan0
loopback * 255.0.0.0 U 0 0 0 lo
default 192.168.2.1 0.0.0.0 UG 0 0 0 wlan0
##################### iwlist scan ###############
#####################mein router###############
wlan0 Scan completed :
Cell 01 - Address: 00:30:BD:C2:C8:30
ESSID:"WG-LAN"
Mode:Managed
Frequency:2.462GHz
Quality:1/1 Signal level:-66 dBm Noise level:-200 dBm
Encryption keyff
Bit Rate:1Mb/s
Bit Rate:2Mb/s
Bit Rate:5.5Mb/s
Bit Rate:11Mb/s
Extra:bcn_int=100
#######################etc/sysconfig/network/ifcfg-wlan0####
BOOTPROTO='static'
BROADCAST='192.168.2.255'
IPADDR='192.168.2.2'
MTU=''
NETMASK='255.255.255.0'
NETWORK='192.168.2.0'
REMOTE_IPADDR=''
STARTMODE='onboot'
WIRELESS_AP=''
WIRELESS_BITRATE='auto'
WIRELESS_CHANNEL='11'
WIRELESS_ESSID='WG-LAN'
WIRELESS_KEY=''
WIRELESS_MODE='Managed'
WIRELESS_NICK='mein nick'
WIRELESS_NWID=''
WIRELESS_POWER='yes'
_nm_name='static-0'
WIRELESS_FREQUENCY=''
#####################anpingen meiner karte mit statischer ip###
root:~ # ping 192.168.2.2
PING 192.168.2.2 (192.168.2.2) 56(84) bytes of data.
64 bytes from 192.168.2.2: icmp_seq=1 ttl=64 time=0.062 ms
64 bytes from 192.168.2.2: icmp_seq=2 ttl=64 time=0.059 ms
64 bytes from 192.168.2.2: icmp_seq=3 ttl=64 time=0.064 ms
64 bytes from 192.168.2.2: icmp_seq=4 ttl=64 time=0.061 ms
64 bytes from 192.168.2.2: icmp_seq=5 ttl=64 time=0.062 ms
64 bytes from 192.168.2.2: icmp_seq=6 ttl=64 time=0.060 ms
64 bytes from 192.168.2.2: icmp_seq=7 ttl=64 time=0.060 ms
64 bytes from 192.168.2.2: icmp_seq=8 ttl=64 time=0.059 ms
64 bytes from 192.168.2.2: icmp_seq=9 ttl=64 time=0.060 ms
64 bytes from 192.168.2.2: icmp_seq=10 ttl=64 time=0.061 ms
64 bytes from 192.168.2.2: icmp_seq=11 ttl=64 time=0.059 ms
########################## anpingen des routers #########
PING 192.168.2.1 (192.168.2.1) 56(84) bytes of data.
From 192.168.2.2: icmp_seq=2 Destination Host Unreachable
From 192.168.2.2 icmp_seq=2 Destination Host Unreachable
From 192.168.2.2 icmp_seq=3 Destination Host Unreachable
From 192.168.2.2 icmp_seq=4 Destination Host Unreachable
vielen dank fuer eure hilfe..