Kein DHCP auf WLAN Interface nach Boot

[cbr]

Nabend,
ich hab mir OpenSuse 10.3 installiert. Die Madiwifi Treiber + Kernelupdate installiert und eingerichtet. Soweit so gut.

Nach einem Neustart bekomme ich keine IP zugeteilt. Ein "rcnetwork restart" klappt dagegen bestens. Bei 10.2 gab es das Problem nicht.
Hier http://www.linux-club.de/viewtopic.php?t=86374&highlight=dhcp+wlan ist das Problem zwar angesprochen worden aber die Lösung leider nicht angegeben.

Auszug aus messages nach dem Booten:

Oct 23 20:14:31 266874g ifup:     lo
Oct 23 20:14:31 266874g ifup:     lo
Oct 23 20:14:31 266874g ifup: IP address: 127.0.0.1/8
Oct 23 20:14:31 266874g ifup:
Oct 23 20:14:31 266874g ifup:     ath0      device: Atheros Communications, Inc. AR5212 802.11abg NIC (rev 01)
Oct 23 20:14:31 266874g ifup-wireless:     ath0      starting wpa_supplicant
Oct 23 20:14:32 266874g kernel: NET: Registered protocol family 17
Oct 23 20:14:32 266874g ifup-dhcp:     ath0      (DHCP)
Oct 23 20:14:32 266874g ifup-dhcp: .
Oct 23 20:14:32 266874g ifup-dhcp: .
Oct 23 20:14:34 266874g firmware.sh[3336]: Cannot find  firmware file 'intel-ucode/06-0d-08'
Oct 23 20:14:34 266874g kernel: IA-32 Microcode Update Driver: v1.14a <tigran@aivazian.fsnet.co.uk>
Oct 23 20:14:34 266874g ifup-dhcp: .
Oct 23 20:14:37 266874g syslog-ng[2341]: last message repeated 2 times
Oct 23 20:14:37 266874g ifup-dhcp: no IP address yet... backgrounding.
Oct 23 20:14:38 266874g ifup:     eth0      device: Broadcom Corporation NetXtreme BCM5751M Gigabit Ethernet PCI Express (rev 11)
Oct 23 20:14:38 266874g ifup:     eth0      Startmode is 'manual'
Oct 23 20:14:38 266874g ifup:     irda0
Oct 23 20:14:38 266874g ifup:               No configuration found for irda0

Es wird zwar "firmware.sh[3336]: Cannot find firmware file 'intel-ucode/06-0d-08' ausgegeben, aber damit kann ich nichts anfangen. Weiß auch nicht ob es relevant ist.
Auf das rcnetwork restart

Oct 23 20:19:07 266874g ifdown:     ath0      device: Atheros Communications, Inc. AR5212 802.11abg NIC (rev 01)
Oct 23 20:19:07 266874g dhcpcd[3275]: terminating on signal 15
Oct 23 20:19:07 266874g dhcpcd-hook: Skipping 'ifdown $INTERFACE -o dhcp' call
Oct 23 20:19:08 266874g ifdown:     eth0      device: Broadcom Corporation NetXtreme BCM5751M Gigabit Ethernet PCI Express (rev 11)
Oct 23 20:19:08 266874g ifdown:     irda0
Oct 23 20:19:08 266874g ifdown:               No configuration found for irda0
Oct 23 20:19:08 266874g ifdown:               Nevertheless the interface will be shut down.
Oct 23 20:19:08 266874g ifup:     lo
Oct 23 20:19:08 266874g ifup:     lo
Oct 23 20:19:08 266874g ifup: IP address: 127.0.0.1/8
Oct 23 20:19:08 266874g ifup:
Oct 23 20:19:09 266874g ntpd[15590]: ntpd 4.2.4p3@1.1502-o Sat Sep 22 01:01:25 UTC 2007 (1)
Oct 23 20:19:09 266874g ntpd[15591]: precision = 1.000 usec
Oct 23 20:19:09 266874g ntpd[15591]: ntp_io: estimated max descriptors: 1024, initial socket boundary: 16
Oct 23 20:19:09 266874g ntpd[15591]: Listening on interface #0 wildcard, 0.0.0.0#123 Disabled
Oct 23 20:19:09 266874g ntpd[15591]: Listening on interface #1 lo, 127.0.0.1#123 Enabled
Oct 23 20:19:09 266874g ntpd[15591]: kernel time sync status 0040
Oct 23 20:19:09 266874g ntpd[15591]: frequency initialized 0.000 PPM from /var/lib/ntp/drift/ntp.drift
Oct 23 20:19:09 266874g ifup:     ath0      device: Atheros Communications, Inc. AR5212 802.11abg NIC (rev 01)
Oct 23 20:19:09 266874g ifup-wireless:     ath0      starting wpa_supplicant
Oct 23 20:19:09 266874g ifup-dhcp:     ath0      (DHCP)
Oct 23 20:19:09 266874g ifup-dhcp: .
Oct 23 20:19:13 266874g syslog-ng[2341]: last message repeated 4 times
Oct 23 20:19:13 266874g kernel: martian source 255.255.255.255 from 192.168.178.1, on dev ath0
Oct 23 20:19:13 266874g kernel: ll header: ff:ff:ff:ff:ff:ff:00:1a:4f:a2:75:de:08:00:45:00:02:40:4e:68:00:00:40:11:b7:9b:c0:a8:b2:01:ff:ff:ff:ff:00:43:0
0:44:02:2c:a5:ef:02:01:06:00:7f:d8:31:19:00:0a:00:00:00:00:00:00:c0:a8:b2:14:c0:a8:b2:01:00:00:00:00:00:0e:9b:a3:73:f6:00:00:00:00:00:00:00:00:00:00:00:
00
Oct 23 20:19:13 266874g avahi-daemon[4173]: Joining mDNS multicast group on interface ath0.IPv4 with address 192.168.178.20.
Oct 23 20:19:13 266874g avahi-daemon[4173]: New relevant interface ath0.IPv4 for mDNS.
Oct 23 20:19:13 266874g avahi-daemon[4173]: Registering new address record for 192.168.178.20 on ath0.IPv4.
Oct 23 20:19:13 266874g modify_resolvconf: Service dhcpcd modified /etc/resolv.conf. See info block in this file
Oct 23 20:19:13 266874g ifup:     ath0      device: Atheros Communications, Inc. AR5212 802.11abg NIC (rev 01)
Oct 23 20:19:14 266874g ntpd[15819]: ntpd 4.2.4p3@1.1502-o Sat Sep 22 01:01:25 UTC 2007 (1)
Oct 23 20:19:14 266874g ntpd[15820]: precision = 2.000 usec
Oct 23 20:19:14 266874g ntpd[15820]: ntp_io: estimated max descriptors: 1024, initial socket boundary: 16
Oct 23 20:19:14 266874g ntpd[15820]: Listening on interface #0 wildcard, 0.0.0.0#123 Disabled
Oct 23 20:19:14 266874g ntpd[15820]: Listening on interface #1 lo, 127.0.0.1#123 Enabled
Oct 23 20:19:14 266874g ntpd[15820]: Listening on interface #2 ath0, 192.168.178.20#123 Enabled
Oct 23 20:19:14 266874g ntpd[15820]: kernel time sync status 0040
Oct 23 20:19:14 266874g ntpd[15820]: frequency initialized 0.000 PPM from /var/lib/ntp/drift/ntp.drift
Oct 23 20:19:14 266874g SuSEfirewall2: /var/lock/SuSEfirewall2.booting exists which means system boot in progress, exit.
Oct 23 20:19:14 266874g syslog-ng[2341]: SIGHUP received, restarting syslog-ng
Oct 23 20:19:14 noname ifup-dhcp: IP/Netmask: 192.168.178.20
Oct 23 20:19:14 noname ifup-dhcp:  / 255.255.255.0
Oct 23 20:19:14 noname ifup-dhcp:  ('noname')
Oct 23 20:19:14 noname ifup-dhcp:
Oct 23 20:19:14 noname ifup:     eth0      device: Broadcom Corporation NetXtreme BCM5751M Gigabit Ethernet PCI Express (rev 11)
Oct 23 20:19:14 noname ifup:     eth0      Startmode is 'manual'
Oct 23 20:19:14 noname ifup:     irda0
Oct 23 20:19:14 noname ifup:               No configuration found for irda0

Wird die IP verteilt und das Interface ist aktiv. Läuft der DHCP-Request in einen Timeoute ? Auffällig ist ev. auch das in den letzten Zeilen der Hostname plötzlich "noname" ist.

Ja damit steh ich erstmal da, vielleicht hat jemand einen Lösungsansatz für mich ?

Vielen Dank für Eure Hilfe

 

[Freecoffee]

Das "noname" steht wohl nur da, weil du angekreuzt hast, dass der PC seinen Namen per DHCP beziehen soll, der DHCP-Server ihm aber keinen zugewiesen hat.